Internet-Draft voucher-security-profile May 2023
Mohammed, et al. Expires 1 December 2023 [Page]
Workgroup:
Anima Working Group
Internet-Draft:
draft-mohammed-anima-voucher-security-profile-00
Published:
Intended Status:
Standards Track
Expires:
Authors:
J. Mohammed
Cisco Systems
R. Haddad
Cisco Systems
S. Raghavan
Cisco Systems
S. Rao
Cisco Systems

Security Profiles in Bootstrap Voucher Artifacts

Abstract

This document describes an extension of the RFC8366 Voucher Artifact in order to support security profiles. This allows the owner to change and customize the security posture of the device dynamically and securely. This lets the owner to selectively enable or disable each of the underlying security parameters that make up the security posture of the device.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 1 December 2023.

Table of Contents

1. Introduction

The [RFC8366] voucher artifact provides a proof from a manufacturer's authorizing signing authority (MASA) of the intended owner of a device. This is used by an onboarding Pledge device in BRSKI ([RFC8995], [I-D.ietf-anima-constrained-voucher]), and SZTP ([RFC8572]).

The security profile for a device can be defined as a sum collection of the settings of the different underlying security parameters that determine the overall security posture of a device. There are many reasons for the need and they include:

1.1. Overview of Proposed Solution

There are various underlying security parameters that are possible. These can be divided into Common, OEM specific and Reserved (for future use).

Some examples of common and standard ones (others may be added in future revisions of the draft) are below.

  • Enable or disable Secure Zero Touch Provisioning (SZTP). This could be used in cases where disabling sZTP is required.
  • Enable or disable Federal Information Processing Standards (FIPS) mode support. This could be needed where FIPS mode need to be disabled or enabled depending on deployment scenarios.
  • Enable or disable Linux Integrity Measurement Architecture (IMA) enforcement. This could be needed where IMA measurement is the need while appraisal is not.

Extensions to standards-based RFC8366 Voucher Artifact handles different and varying security postures for the owner that would have otherwise needed complex manufacturing end-customer security profile handling and tracking.

This allows ease of use and management for owners by providing secure ways for dynamic changes and alteration of security postures for the owner, at scale.

The OEM specific aspects are kept private while the Reserved aspects are reserved for future use.

2. Terminology

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.

Security Profile Voucher:

A security profile voucher is an [RFC8366] format voucher that has additional fields to provide configuration details of all the underlying security parameters that determine the overall security posture of the device under consideration.

3. Security Profile Voucher Artifact

The following tree diagram shows the extensions to the [RFC8366] voucher.

There are a few new fields:

security-profile-enable-flag:

A global enable flag to the pledge that security profiles for this pledge is enabled(true) or not (false). With default, this flag is false, which is consistent with the voucher artifact in RFC8366.

security-profile-selector:

Bitmask value of all the underlying security parameters

module: ietf-voucher-security-profile

  grouping voucher-security-profile-grouping:
    +-- voucher
       +-- created-on                          yang:date-and-time
       +-- expires-on?                         yang:date-and-time
       +-- serial-number                       string
       +-- idevid-issuer?                      binary
       +-- pinned-domain-cert?                 binary
       +-- domain-cert-revocation-checks?      boolean
       +-- nonce?                              binary
       +-- last-renewal-date?                  yang:date-and-time
       +-- security-profile-enable-flag?       boolean
       +-- security-profile-selector?          bits

3.1. YANG Module

This module uses the grouping that was created in [RFC8366] to extend the definition.

<CODE BEGINS> file "[email protected]"

module ietf-voucher-security-profile {
  yang-version 1.1;

  namespace
    "urn:ietf:params:xml:ns:yang:ietf-voucher-security-profile";
  prefix "security-profile";

  import ietf-restconf {
    prefix rc;
    description
      "This import statement is only present to access
       the yang-data extension defined in RFC 8040.";
    reference "RFC 8040: RESTCONF Protocol";
  }

  import ietf-voucher {
    prefix "iv";
  }

  organization
   "IETF ANIMA Working Group";

  contact
   "WG Web:   <http://tools.ietf.org/wg/anima/>
    WG List:  <mailto:[email protected]>
    Author:   Srihari Raghavan
              <mailto:[email protected]>";

  description
  "This module extends the RFC8366 voucher format to provide
   a mechanism by which the authority can configure the security
   posture of the device.

   The key words 'MUST', 'MUST NOT', 'REQUIRED', 'SHALL',
   'SHALL NOT', 'SHOULD', 'SHOULD NOT', 'RECOMMENDED', 'MAY',
   and 'OPTIONAL' in the module text are to be interpreted as
   described in BCP 14 RFC 2119, and RFC8174.";

  revision "2023-05-30" {
    description
     "Initial version";
    reference
     "RFC XXXX: Voucher extensions for security profile";
  }

  rc:yang-data voucher-security-profile-artifact {
    // YANG data template for a voucher.
    uses voucher-security-profile-grouping;
  }

  typedef bitmask32 {
    type uint32;
      description
        "The bitmask32 type represents a non-negative integer
         that represents a bit mask type field with each bit
         set (or unset) representing a different intent along
         with a range of bits/values representing a group.  Using
         an appropriate mask, the individual bits can be set/reset.
         In addition, a range of bits can also be manipulated using
         an appropriate mask.

         The 'type bits' and 'position' yang based bit fields do
         not lend itself easily to range based comparisons and
         hence the need for a customized type definition.

         The bitmask32 type can be used for configuration
         schema nodes.  A default statement can be used in
         combination with the type bitmask32.";

       reference
        "RFC 2578: Structure of Management Information Version 2
                   (SMIv2)";
  }

  // Grouping for security parameters forming the security profile
  //
  // These are separated into two-groups: standardized and OEM.
  //
  // The security-parameters-standard are subject to standards
  // for inter-operability while the OEM range is expected to be
  // implementation dependent.
  //
  //
  grouping security-parameters-oem-group {
    leaf security-params-oem-value {
      type bitmask32;
      description
        "Bit map for the different underlying security
         parameters. This is only valid if
         security-profile-enable-flag is true.

         Range: - 0x1, 0x2, 0x4..0x8000..0x10000..0x800000000
        ";
    }

    leaf security-params-oem-mask {
      type bitmask32;
      description
        "This represents the mask for the value above.
         If this mask is on for a bit, the corresponding
         value of the bit will be treated accordingly.  If
         the mask is off, the value of the bit could be
         treated as a don't care or default value";
    }
    description
      "This grouping represents the OEM group of the
       security parameters.
      ";
  }

  grouping security-parameters {
    leaf security-parameters-standard {
      type bits {
        bit reserved { position 0; }
        bit last;
      }
      description
        "The specific bits are expected to be defined
         following discussions with WG members and some examples
         could be FIPS mode handling, SELinux handling,
         Linux IMA handling etc., which could decide the
         overall security posture of a device.";
    }

    container security-parameters-oem {
      uses security-parameters-oem-group;
      description
        "This is the overall security parameters
         for OEMs.";
    }

    description
      "This represents the overall security
       parameters group that encompasses the
       standards and oem based parameters.
      ";
  }

  grouping voucher-security-profile-grouping {
    description
      "Grouping to allow reuse/extensions in future work.";

    uses iv:voucher-artifact-grouping {
      augment "voucher" {
        description "Base the security profile voucher
                     upon the regular voucher";

        leaf security-profile-enable-flag {
          type boolean;
          description
            "A global enable flag to the pledge that security
             profiles for this pledge is enabled(true) or
             not (false). With default, this flag is false,
             which is consistent with the voucher
             artifact in RFC8366. ";
        }

        uses security-parameters;

      }
    }
  }
}

<CODE ENDS>

4. Enhanced Pledge Behavior

The use of a security profile voucher requires changes to how the pledge evaluates the voucher that is returned to by the Registrar.

If the pledge supports this extension, it looks for security-profile-enable-flag and if set, the security-profile-selector MUST be processed.

5. Changes to Registrar Behavior

The Registrar is the component that authenticates the pledge, makes authorization decisions, and distributes vouchers. If the extensions are supported, the Registrar MAY process a security profile selector request from owner that identifies what underlying security parameters need to be enabled in the security-profile-selector send down to the pledge as part of these extensions.

The registrar MUST enable or disable the underlying security profile parameters to match the security profile selector request. The details of the security profile selector request is beyond the scope of the document, but it is expected that it roughly matches the security-profile-selector fields.

6. Privacy Considerations

TBD

7. Security Considerations

TBD

8. IANA Considerations

This document requires the following IANA actions:

8.1. The IETF XML Registry

This document registers a URI in the "IETF XML Registry" [RFC3688]. IANA is asked to register the following:

     URI: urn:ietf:params:xml:ns:yang:ietf-voucher-security-profile
     Registrant Contact: The ANIMA WG of the IETF.
     XML: N/A, the requested URI is an XML namespace.

8.2. YANG Module Names Registry

This document registers a YANG module in the "YANG Module Names" registry [RFC6020]. IANA is asked to register the following:

     name:         ietf-voucher-security-profile
     namespace:urn:ietf:params:xml:ns:yang:ietf-voucher-security-profile
     prefix:       NONE
     reference:    THIS DOCUMENT

9. Implementation Considerations

Implementation of the proposal is under active development.

10. Acknowledgements

TBD

11. Changelog

12. References

12.1. Normative References

[I-D.ietf-anima-constrained-voucher]
Richardson, M., Stok, P. V. D., Kampanakis, P., and E. Dijk, "Constrained Bootstrapping Remote Secure Key Infrastructure (BRSKI)", Work in Progress, Internet-Draft, draft-ietf-anima-constrained-voucher-20, , <https://www.ietf.org/archive/id/draft-ietf-anima-constrained-voucher-20.txt>.
[RFC2119]
Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, , <https://www.rfc-editor.org/info/rfc2119>.
[RFC8174]
Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, , <https://www.rfc-editor.org/info/rfc8174>.
[RFC8366]
Watsen, K., Richardson, M., Pritikin, M., and T. Eckert, "A Voucher Artifact for Bootstrapping Protocols", RFC 8366, DOI 10.17487/RFC8366, , <https://www.rfc-editor.org/info/rfc8366>.
[RFC8995]
Pritikin, M., Richardson, M., Eckert, T., Behringer, M., and K. Watsen, "Bootstrapping Remote Secure Key Infrastructure (BRSKI)", RFC 8995, DOI 10.17487/RFC8995, , <https://www.rfc-editor.org/info/rfc8995>.

12.2. Informative References

[RFC3688]
Mealling, M., "The IETF XML Registry", BCP 81, RFC 3688, DOI 10.17487/RFC3688, , <https://www.rfc-editor.org/info/rfc3688>.
[RFC6020]
Bjorklund, M., Ed., "YANG - A Data Modeling Language for the Network Configuration Protocol (NETCONF)", RFC 6020, DOI 10.17487/RFC6020, , <https://www.rfc-editor.org/info/rfc6020>.
[RFC8040]
Bierman, A., Bjorklund, M., and K. Watsen, "RESTCONF Protocol", RFC 8040, DOI 10.17487/RFC8040, , <https://www.rfc-editor.org/info/rfc8040>.
[RFC8572]
Watsen, K., Farrer, I., and M. Abrahamsson, "Secure Zero Touch Provisioning (SZTP)", RFC 8572, DOI 10.17487/RFC8572, , <https://www.rfc-editor.org/info/rfc8572>.

Appendix A. Extra references

RFC Editor, please remove this section. This section lists references in the YANG. [RFC8174], [RFC8040].

Authors' Addresses

Jabir Mohammed
Cisco Systems
Reda Haddad
Cisco Systems
Srihari Raghavan
Cisco Systems
Sandesh Rao
Cisco Systems